4 posts • Page 1 of 1
old loads from my backups work fine but when I try to simulate the latest download from the taranis plus, the switches and pots do not show up in the simulator. Went back and forth: olds work and new .otx does not show switches and pots for any of the models in the simulator. The compare function does not reveal anything: one model for example only has a trim difference. I don't see anything in the simulator view options. Ideas? where can I look?
Hum found why (in my case), I was not using the proper radio profile (was using the x9d instead of the x9d+) AND after changing it I had to click the "Store calib and hw settings in selected profile" a the bottom right of the (model) radio settings two make them show up.