taranis center point drift
taranis center point drift
I set my center points using subtrim to 1500. Check later and the roll is moved about 25 points down to 1480 or so. Re-trim and it moves again. Do I need to reflash the firmware? Have a gimble problem? I think it caused a couple of crashed last flights. Thanks!
Re: taranis center point drift
Update: In another test, I set all at 1500 and then rolled right and left a couple of time. Instead of returning to 1500 or no input it stayed at 1482. Anyone know what could cause this?
Re: taranis center point drift
Defective gimbal? Maybe just the pot not well tightened in place...
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: taranis center point drift
I did have a loose pot on one of my Taranis Gimbals and to fix it from moving, I used a little Super Glue on it.
You may want to upgrade your Gimbals to the M9 Gimbals.
Bob B.
You may want to upgrade your Gimbals to the M9 Gimbals.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
Re: taranis center point drift
Thanks to both, will open the taranis and check gimbal, but thinking seriously about going M9.
dudley
dudley