9xr-pro and XJT module not working on pxx

[chubb]

Hello,

The XJT and X6R are bound, but I am not getting any servo movement with pxx, if I switch to ppm the servos will move. What's going on?

Sent from my LG-H811 using Tapatalk

[phoenixangel]

Sounds like the rx is in d8 or D_ mode

[chubb]

It's not, I put both switches down and picked D16 in the menu. The RX? I bound it without any jumpers isn't that D16?

Sent from my LG-H811 using Tapatalk

[phoenixangel]

are u binding it while in pxx just curious if it binds with the radio in pxx I am really confused

[chubb]

Yes it binds in pxx

Sent from my LG-H811 using Tapatalk

[Kilrah]

Are you binding using the menu option? You must NOT use the button and switches on the module when in PXX mode, only the menu options.

[chubb]

No, I'm using the button, what position should the switch be in? Both down?

Sent from my LG-H811 using Tapatalk

[Kilrah]

It doesn't actually matter as long as they're NOT both up as whatever's received on PXX overrides them.

[chubb]

I'm gonna try that.

Sent from my LG-H811 using Tapatalk

[chubb]

OK, I am getting telemetry but no servo controls. What the heck is going on? I'm in D16 mode, PXX. But! If I switch to PPM I have full control of the plane but no telemetry.

Sent from my LG-H811 using Tapatalk

[chubb]

Please help!

Sent from my LG-H811 using Tapatalk

[MikeB]

What firmware are you using, and what revision.
If you are on ersky9x, please flash the latest test version from here: viewtopic.php?f=7&t=4676#p65894 (ersky9xProvR219j.zip). There has been a possible problem with an earlier test version on the 'PRO where the PXX signal wasn't being sent. I still don't know why it wasn't being sent, as the code is the same for the SKY/AR9X boards and they work.

Mike.

[chubb]

What firmware are you using, and what revision.
If you are on ersky9x, please flash the latest test version from here: viewtopic.php?f=7&t=4676#p65894 (ersky9xProvR219j.zip). There has been a possible problem with an earlier test version on the 'PRO where the PXX signal wasn't being sent. I still don't know why it wasn't being sent, as the code is the same for the SKY/AR9X boards and they work.

Mike.

I am on one of the test versions, I'll flash the new one when I get home from work and report back! Thanks!


Sent from my iPad using Tapatalk

[chubb]

That worked, thanks Mike!

Sent from my LG-H811 using Tapatalk