Frysky and DJT/DHT modules.

[HAILME123]

I am sorry for this question but I have just begun RC and 14 years of age.. Help me out

I currently believe that the 9Xtreme board is restricted to the ERSKY9X firmware. Is the DJT Frsky transmitter module restricted on any features due to this firmware, such as the two way antenna, where you can get data from the receiver (battery, GPS, Signal strength etc)

One more thing, where is the plug for the DJT (the non-do it yourself module, the that is boxed etc..) is it on the back of the module or do I have to desolder some plug in the box or conveniently I could get the DHT (do it your self module). Is there a difference?

[MikeB]

Ersky9x fully supports the DJT (and XJT) with telemetry.
The DJT plugs directly in to the module bay. You then just need to connect the two telemetry wires (black and white) from the 9Xtreme to the Tx and Rx connections on the back of the DJT to get telemetry.
I can't locate the thread that shows this connection at the moment.

Mike.

[bob195558]

Hi HAILME123,
For more information about external DJT module Telemetry connections, see here: (viewtopic.php?f=126&t=8506).
Also see 9Xtreme Connecting XJT Module, which has some of the same info for the DJT module: (viewtopic.php?f=126&t=7771).
Some other info here too: (viewtopic.php?f=126&t=7820).

Bob B.

[HAILME123]

Thanks for your contribution. Now I can use the DJT (Non-do it your self module) I was a little bit shaky before you guys answered. Thanks!

[HAILME123]

Hi HAILME123,
For more information about external DJT module Telemetry connections, see here: (viewtopic.php?f=126&t=8506).
Also see 9Xtreme Connecting XJT Module, which has some of the same info for the DJT module: (viewtopic.php?f=126&t=7771).
Some other info here too: (viewtopic.php?f=126&t=7820).

Bob B.

On the DJT module do I need to do anything else, besides extending the wires?

[jhsa]

No.

João