So I did something about that.
I bought those inserts from China http://www.banggood.com/100pcs-M34mm-H6 ... 71077.html
Use others if you like. But those work just fine.
Then I took a 4mm drill and drilled vertically down the plastic stems in the back of the case. No worries the drill will follow the old hole quite nicely.
Securing the inserts is a little bit of a challenge. A slightly smaller drill hole would have been ideal. 4mm is just a snug fit. But not enough meat to melt the brass insert right into the plastic.
With that option out, I resorted to glue. With the screw well waxed in I epoxied the whole thing in.
I guess if any one of you tried this same mod, give it a shot if you can just melt the inserts right into the original holes.
PS: I used those screws. http://www.banggood.com/100PcsM3-Bolts- ... 52124.html
If you want to import them from China too.
