maybe wrong section here, but currently I'm not sure where I should post it.
What I have already done, I decode the mavlink message in a arduino, and send it via serial interface to the
Sport from a X8R receiver.
At the moment, I'm using the RPM_SENSOR_ID from SPort.
This is working, but to be serious, the SPort protocol is not so clear for me.
Is there any documentation around, about the SPort protocol?
What is my target?
I want to use the existing telemtry data from my Flightcontrol, and see it on my Taranis
The most important, Vbat, state and so on.
So, any hints and help would be perfect.
Thanks
