hi all
i had taranis x7 problem a OUPUT volt for modul. i checked and detect pin ON/off power for modul on stm32 is dead. So i can replace a STM32 other , but i only can buy a stm32f205VCT6 is not VET6 . So it can work ?
thanks
help hardware X7 taranis
Re: help hardware X7 taranis
VCT6 has half the memory which is not enough.
Should be easy to find the correct one on ebay or such.
Should be easy to find the correct one on ebay or such.
Re: help hardware X7 taranis
This should be OK.
Re: help hardware X7 taranis
Hi Kilrah
To x7 work only need power 3v3 ? i have little difficult turn on X7 .
connect USB ok with STM32 DFU .i try move 2 trim and power 3v3 for stm32. but not see anything on screen LOL.
So i wonder about way X7 turn on
To x7 work only need power 3v3 ? i have little difficult turn on X7 .
connect USB ok with STM32 DFU .i try move 2 trim and power 3v3 for stm32. but not see anything on screen LOL.
So i wonder about way X7 turn on
Last edited by happyrc1 on Sat Dec 08, 2018 10:40 am, edited 1 time in total.
Re: help hardware X7 taranis
Did you flash firmware yet? Need to do so in DFU mode.