Taranis setup for ailerons using two servos
Taranis setup for ailerons using two servos
Could somebody assist me please. I am using a Taranis with the FrSky 8 channel HV Rx. I have set up the Tx to control two aileron servos, both using identical settings, this includes rates and expo. All is well at the hi rate setting, but when I set mid or low rates only one aileron responds, the other staying at the hi rate. Both rate settings are identical. Am I missing something? I would appreciate your comments.
Re: Taranis setup for ailerons using two servos
Look at justfly.solutions perhaps that os something for you.
Re: Taranis setup for ailerons using two servos
Thats a pretty poor answer. sending the guy to a pay for info site. open systems is about helping each other isnt IT.
I am too much a newb to help much but I would clear the settings and redo just in case you were distracted the 1st time and missed a step
I am too much a newb to help much but I would clear the settings and redo just in case you were distracted the 1st time and missed a step
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Taranis setup for ailerons using two servos
Do you have two free receiver channels ?
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Taranis setup for ailerons using two servos
Here I am using CH1 for one Ail servo and CH2 for the other Ail servo.
I am using erSky9x on Taranis, but I think it still works the same way on OpenTx. They are also tied in with Switches SA and SB.
I am using erSky9x on Taranis, but I think it still works the same way on OpenTx. They are also tied in with Switches SA and SB.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).