Taranis setup for ailerons using two servos

[bobcat52]

Could somebody assist me please. I am using a Taranis with the FrSky 8 channel HV Rx. I have set up the Tx to control two aileron servos, both using identical settings, this includes rates and expo. All is well at the hi rate setting, but when I set mid or low rates only one aileron responds, the other staying at the hi rate. Both rate settings are identical. Am I missing something? I would appreciate your comments.

[lshems]

Look at justfly.solutions perhaps that os something for you.

[flyoz]

Thats a pretty poor answer. sending the guy to a pay for info site. open systems is about helping each other isnt IT.

I am too much a newb to help much but I would clear the settings and redo just in case you were distracted the 1st time and missed a step

[bob195558]

Do you have two free receiver channels ?

[bob195558]

Here I am using CH1 for one Ail servo and CH2 for the other Ail servo.
I am using erSky9x on Taranis, but I think it still works the same way on OpenTx.

CH1 for one Ail servo and CH2 for the other Ail servo

They are also tied in with Switches SA and SB.