Hi folks,
I want to limit the travel of the canards on my model so that they will only operate in one direction (canards move down when up elevon is applied).
Currently they are on a separate channel which is slaved to the elevon input but they are moving in both directions.
any help would be apreciated.
thanks
CK
Limiting servo travel to one direction
Limiting servo travel to one direction
FrSky convert! Farewell Spektrum!
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Limiting servo travel to one direction
On the mix for their channel, just add the curve x>0 (or x<0). It may be called a function on later versions of openTx.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Limiting servo travel to one direction
Thanks Mike.
I'll give that a try and see how I get on.
I'll give that a try and see how I get on.
FrSky convert! Farewell Spektrum!