Hi,
I just received my taranis Plus and everything's working fine but the haptic feedback,
the Firmware version is 2.0.9
In the Radio setup I have set it to "ALL" and "length" "strenght" set to max value,
I also tried to assign the custom function "haptic" to a switch but it doesnt work...any clues?
Thanks everybody!
Taranis Plus Haptic feedback not working?
-
- Posts: 1
- Joined: Wed Nov 12, 2014 9:03 pm
- Country: -
Re: Taranis Plus Haptic feedback not working?
I just bumped another thread about this. I added the module a few months ago but it never worked. Will update my Taranis to see whether this was accidentally fixed in the meantime.
Re: Taranis Plus Haptic feedback not working?
I found something similar after I installed a haptic module in my X9D . You need to download the firmware with the HAPTIC function enabled.
Go to the SETTINGS menu in Companion and ensure that you check the box for HAPTIC.
You'll be given a prompt to say that you've not downloaded this before, accept this and carry on.
You should find that works once you install the new firmware.
Go to the SETTINGS menu in Companion and ensure that you check the box for HAPTIC.
You'll be given a prompt to say that you've not downloaded this before, accept this and carry on.
You should find that works once you install the new firmware.
FrSky convert! Farewell Spektrum!
Re: Taranis Plus Haptic feedback not working?
I fixed the problem in the end. It was the polarity of the wires on the haptic board. D'oh!