Hello,
i have 2 Taranis they are connect with an Stereo Male to Male Cable.
I also have to Frsky X8r Receiver.
I fly a Multicopter with an 3 Axis Brushless Gimbal.
In Companion 9X i have written the program for these Taranis. But after the Firmware Update to 2.0.8 the Channels from Slave pulsing on the Master Channel. My PPM Setup: 22,5ms 300 u negativ.
I use Channel TR1 - TR 11 for Master - Slave / CH 12 - CH 16 on the second X8r for LED, Servo ........
Can somebody help me ?
TARANIS to TARANIS Signal pulsing
Re: TARANIS to TARANIS Signal pulsing
Hy,
Frametime 22,5ms is too less for 11 channels
its only ok for 9 channels
9x2ms + 4ms Synchro = 22ms
take 27ms for 11 or 12 channels
12x2ms + 4ms Synchro = 28ms
Helle
Frametime 22,5ms is too less for 11 channels
its only ok for 9 channels
9x2ms + 4ms Synchro = 22ms
take 27ms for 11 or 12 channels
12x2ms + 4ms Synchro = 28ms
Helle