Hi,
is it possible to connect the FAS-100 Current Sensor with a D4R-II Receiver? I tried yesterday but didn't get any results on my telemetry screen. Using a D8R works fine...
Best regards
Marcus
FAS-100 and D4R-II
-
- Posts: 750
- Joined: Tue Dec 27, 2011 11:22 pm
- Country: United States
- Location: Carson City, Nv
Re: FAS-100 and D4R-II
I would think it would connect just like the vario. Look at
http://www.eflightwiki.com/eflightwiki/ ... ent_Sensor
and then click on the link.
6.4 FAS-40 Current Sensor
page down a bit and it shows a picture. It appears that one wire has to be moved.
I haven't tried it yet. So YMMV
http://www.eflightwiki.com/eflightwiki/ ... ent_Sensor
and then click on the link.
6.4 FAS-40 Current Sensor
page down a bit and it shows a picture. It appears that one wire has to be moved.
I haven't tried it yet. So YMMV
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1
Re: FAS-100 and D4R-II
Tried it exactly that way, but didn't work...
Re: FAS-100 and D4R-II
Yellow wire from the FAS' 3-pin plug (TX) should go to the receiver's RX pin, black to GND.
Re: FAS-100 and D4R-II
Thats what I tried. I'll check it again in the evening, Thanks.
Re: FAS-100 and D4R-II
Tx... RX... Doh.