I have a FrSky Horus X10S Express with OpenTx 2.3.11 and Skyzone SKY04X goggles. These goggles have built-in head tracking.
I want to use my switch A for three modes of head tracking:
1. Switch A up: my camera is going to a fixed position. This is working.
2. Switch A middle: I use a slider to control the camera. It's working.
3. Switch A down: I want to use the head tracking from the goggles. This is NOT working.
In the SKY04X goggles I have set head tracking on and PPM channels 5-6. The connection via cable is working.
In my radio I have made the following settings:
In Model Setup I have set Trainer Mode to Master/Jack
In Inputs I have an input 9 with three lines:
Line 1 is for the fixed position and line 2 is for the slider (both are working).
Line 3 is for head tracking and has the following settings:
Source: T6
Switch: ---
In Mixer I have nothing special.
In Special Functions I have an SF2:
Switch A down, Trainer Chans and activated.
In the Monitor everything is working, except if I set switch A down. I see the channels 5 and 6 moving with the goggles, although my output should be on channel 9. But also all other channels are affected. Ch 1-4 are on 4%, and Ch 17-32 are jumping all over the place.
What is wrong with my system?
Head Tracking Setup not working
Re: Head Tracking Setup not working
T6 is trim 6, you want TR6.
You do NOT want a Trainer special function, with the one you have all channels are taken from the head tracker which is why everything does a mess.
The outputs are determined by the mixer, the order of inputs is meaningless. So to have something output on CH9 you need it on CH9 in the mixer.
You do NOT want a Trainer special function, with the one you have all channels are taken from the head tracker which is why everything does a mess.
The outputs are determined by the mixer, the order of inputs is meaningless. So to have something output on CH9 you need it on CH9 in the mixer.
Re: Head Tracking Setup not working
Thank you, it is working now.