I want to program a function to only be on for 20 seconds
-
- Posts: 1
- Joined: Mon Jan 18, 2021 1:20 am
- Country: -
I want to program a function to only be on for 20 seconds
I’m working on my trex 700n and I have a on board glow igniter that is turner on by channel 8 SC But I would like it only be on for 20 seconds so I don’t forget and burn up the glow plug . I’ve read through logical switches but I’m not Smart enough to figure out how to make this work. Thanks in advance
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: I want to program a function to only be on for 20 seconds
I assume you are running openTx (and not erskyTx).
Set up a logical switch to:
AND SCv SCv duration(20.0), then use the logical switch to control channel 8.
When you move SC to SCv, the logical switch will turn on for 20 seconds.
Mike
Set up a logical switch to:
AND SCv SCv duration(20.0), then use the logical switch to control channel 8.
When you move SC to SCv, the logical switch will turn on for 20 seconds.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!