Two RSSI Values
Two RSSI Values
Is there any way to change the RSSI ID of a receiver so that if you have two receivers bound to a model (D8 & D16) you can stop the RSSI values being merged and see both? (I do want both.)
Re: Two RSSI Values
Explain your setup a bit better, because you can't bind 2 receivers in different modes with just the internal module.
Re: Two RSSI Values
The set up is 2013 Taranis X9D with an external XJT module in D8 mode communicating with a D8R-XP, this is flying the plane with a FBVS-01 monitoring the flight battery. The Internal module in LBT D16 mode is bound to a R-XSR which does nothing other than report S-PORT sensor data. The two are not necessarily in the same place at the same time which is why I would like both RSSI values or at least not have them combined.Explain your setup a bit better, because you can't bind 2 receivers in different modes with just the internal module.
Re: Two RSSI Values
You cannot get telemetry data from 2 modules on an X9D. Both modules are connected to the same telemetry line and will continually corrupt each other's data, only one may provide telemetry at a time.
XJT needs to be set to the "disable telemetry" mode if it's to be used simulataneously with the internal module.
XJT needs to be set to the "disable telemetry" mode if it's to be used simulataneously with the internal module.
Re: Two RSSI Values
OK - ThanksKilrah wrote: ↑Wed Mar 18, 2020 11:49 am You cannot get telemetry data from 2 modules on an X9D. Both modules are connected to the same telemetry line and will continually corrupt each other's data, only one may provide telemetry at a time.
XJT needs to be set to the "disable telemetry" mode if it's to be used simulataneously with the internal module.