openrcforums

As in the title: I've succesfully bound an x8r to my X9D (green led and telemetry feedback) but no response at any output channel. Only regular beeps from the motor one by one. What could be the case? Thanks in advance.

Do you have any mixes set in the mixer page?

No, it's a new model, just standard functions to start with (TAER).

if you don't have any mixes in the mixer menu, than nothing will work.

João

Stupid me, I was still in the Spektrum mode.. Of course I have to do the mixes.

Edit: I copied an existing model in the TX which works flawless, but with this receiver the result is the same: it binds, green led, telemetry active, but no signal on the RX pins. It may be a faulty receiver.

Are you sure it is bound??

João

And bound in 1-8 mode, not 9-16?

It is bound: green led and telemetry readout. And I bound it to 1-8, telemetry on.

At this point I think we should ask you for pictures of your settings in the mixer menu and the inputs menu.

João

Sent from my BLN-L21 using Tapatalk

Here you go.

As I said: this is a copy of a flawless working file for another plane, I only changed the name and the # of the RX.

Do you have another receiver you can test?

João

Sent from my BLN-L21 using Tapatalk

Yes. I tried it and that one (also an X8R) was OK. So it isn't the programming.

Is there any way to reset the receiver to factory settings, other than updating the firmware?

There are no "settings" nor a way to reset any. Try updating the firmware on it, if it still doesn't work it looks like it's just defective.

I have updated the firmware, no change. Unless somebody has a solution, I consider it to be defective indeed.

Try binding using different RxNums. The S6R/S8R receivers have a problem with some Tx modules where only some RxNums work, they bind but don't operate, just possibly this is happening with your X8R.

Mike

I tried different numbers, unfortunately no difference. I'll contact the webshop.