Mobula7 v2 and Q7 beeping

[rcostarelli]

Hi, I just recently bought the Mobula7 and the Trannis Q7. I'm able to get it up in the air, but when I arm it, it beeps until I throttle up and spin the motors. I feel like its a failsafe thing, but I can't figure it out.

I have it "not to spin motors" when armed set. if I change that to on or turn on airmode then its don't beep, because the motors are spinning. Once the motors start to spin the beeping stops

any suggestions?

thanks
Robert

[Kilrah]

I think that's an intentional warning to let people know that it's armed and they should keep away. At this point if you hit the throttle inadvertently the thing jumps into their face.

[rcostarelli]

is there a workaround? other than turning off motor stop? I tried to find what alarm is going off, by turning every alarm off, but that didn't work...

[Kilrah]

I don't know, you need to read the documentation of the firmware your FC is running.