Page 1 of 1
Failsafe Programming
Posted: Tue Apr 16, 2019 7:37 pm
by rwhammer
I know you can program lots of different things with Lua, but I have not yet learned the language. I was wondering if there was a way to program a Failsafe that will do something like this? Rudder right turn for 10 seconds then straighten out while gradually lowering throttle speed. If there is no way then perhaps it could be a suggestion for future RX.
Re: Failsafe Programming
Posted: Tue Apr 16, 2019 8:08 pm
by jhsa
The failsafe is most of the times handled by the receiver..
The receiver enters failsafe because it lost connection with the transmitter.. So, programming failsafe on the TX is kinda useless
João
Re: Failsafe Programming
Posted: Tue Apr 16, 2019 8:50 pm
by rwhammer
No way yet to program a rx? Hopefully maybe in the future.
Re: Failsafe Programming
Posted: Wed Apr 17, 2019 12:19 am
by MikeB
The "best" option would be a S6R or S8R. In failsafe, you may enable "auto level" mode, together with some rudder and no throttle. This should result in a continuous, flat, descending turn.
Mike
Re: Failsafe Programming
Posted: Wed Apr 17, 2019 1:07 am
by rwhammer
I actually have a X8R. Will that do the same thing?
Re: Failsafe Programming
Posted: Wed Apr 17, 2019 3:26 am
by Kilrah
No. The X8R is just a receiver, the SxR's are receivers with built-in stabilizers.
Re: Failsafe Programming
Posted: Thu Apr 18, 2019 11:49 pm
by rwhammer
So FrSky doesn't make a rx with stabilization and telemetry?
Re: Failsafe Programming
Posted: Fri Apr 19, 2019 12:52 am
by rdeanchurch
FrSky's S6R and S8R have stabilization and telemetry as Kilrah posted.