Taranis x9 plus channels not working
Taranis x9 plus channels not working
I recently did the 2.2.2 firmware update and the only thing to work are switches and throttle. Yaw roll and pitch do not work and I'm not sure what to do since nobody had this problem.
-
- Posts: 750
- Joined: Tue Dec 27, 2011 11:22 pm
- Country: United States
- Location: Carson City, Nv
Re: Taranis x9 plus channels not working
Are you using a flight controller? If so is it setup correctly?
The easiest way for someone to help is to post your .otx and note which model you are working on.
The easiest way for someone to help is to post your .otx and note which model you are working on.
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1
Re: Taranis x9 plus channels not working
.otx is 2.2.2 and model is quad but any model I make only throttle works. This was after flashing to the 2.2.2 firmware which I followed a known YouTube and everything worked fine but now the right stick has no response. Also yaw/rudder no response.
Re: Taranis x9 plus channels not working
Works now.. needed to be calibrated.
-
- Posts: 750
- Joined: Tue Dec 27, 2011 11:22 pm
- Country: United States
- Location: Carson City, Nv
Re: Taranis x9 plus channels not working
Good news!
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1