Taranis x9 plus channels not working

General Help and support for the Taranis Radio.
Post Reply
Fiveoh4
Posts: 3
Joined: Thu Oct 04, 2018 10:21 pm
Country: -

Taranis x9 plus channels not working

Post by Fiveoh4 » Thu Oct 04, 2018 10:23 pm

I recently did the 2.2.2 firmware update and the only thing to work are switches and throttle. Yaw roll and pitch do not work and I'm not sure what to do since nobody had this problem.

rdeanchurch
Posts: 600
Joined: Tue Dec 27, 2011 11:22 pm
Country: -
Location: Rio Vista. CA

Re: Taranis x9 plus channels not working

Post by rdeanchurch » Thu Oct 04, 2018 11:38 pm

Are you using a flight controller? If so is it setup correctly?
The easiest way for someone to help is to post your .otx and note which model you are working on.
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1

Fiveoh4
Posts: 3
Joined: Thu Oct 04, 2018 10:21 pm
Country: -

Re: Taranis x9 plus channels not working

Post by Fiveoh4 » Fri Oct 05, 2018 12:01 am

.otx is 2.2.2 and model is quad but any model I make only throttle works. This was after flashing to the 2.2.2 firmware which I followed a known YouTube and everything worked fine but now the right stick has no response. Also yaw/rudder no response.

Fiveoh4
Posts: 3
Joined: Thu Oct 04, 2018 10:21 pm
Country: -

Re: Taranis x9 plus channels not working

Post by Fiveoh4 » Fri Oct 05, 2018 12:39 am

Works now.. needed to be calibrated.

rdeanchurch
Posts: 600
Joined: Tue Dec 27, 2011 11:22 pm
Country: -
Location: Rio Vista. CA

Re: Taranis x9 plus channels not working

Post by rdeanchurch » Fri Oct 05, 2018 12:41 am

Good news!
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1

Post Reply

Return to “General help (FrSky Taranis radio)”