Hi
I have the Taranis and V2.2.1 and my receiver is a XSR SBUS 16 channels.
I have choices in the bind menu,
I put D16, ch1-ch16
But which one of these should I bind with if I want to control an FC sbus for a drone usinf the sbus 3 pins connector?.
Ch1-ch8 telemetry on'
ch1-ch8 telemetry off
ch1-ch16 telemetry on
ch1-ch16 telemetry off.
And in the mixer should I user channels 1 to 8 or 9 to 16?
Thanks
RTG
XSR receiver to bind for a drone sbus FC
-
- Posts: 284
- Joined: Sat Apr 16, 2016 11:33 pm
- Country: -
Re: XSR receiver to bind for a drone sbus FC
Telemetry as desired, the other doesn't matter as that's for the servo pins and does NOT affect SBUS.
-
- Posts: 284
- Joined: Sat Apr 16, 2016 11:33 pm
- Country: -
Re: XSR receiver to bind for a drone sbus FC
Thanks Kilrah.
I found my problem, I need to configure the UART3 port on my FC. Forgot it.
Sorry my bad, I thought my binding did not work but it did.
And you are right, SBUS is not affected.
RTG
I found my problem, I need to configure the UART3 port on my FC. Forgot it.
Sorry my bad, I thought my binding did not work but it did.
And you are right, SBUS is not affected.
RTG