openrcforums

Hi,

Question: What is the easiest and fastest way to copy a model from Taranis X9D to Taranis X7?
I am aware that graphics and sound files are different and will need to adjust.
I just want to find out if there is a way to redo all of the menus and fine tune and adjust after.

Thanks
RTG

Select an X7 profile in companion. Connect and read X7. Disconnect X7, connect and read X9, disconnect X9. Drag model from X9's window to X7's window. Close X9 window. Check copied model and correct any invalid switch/pot assignments. Connect X7 and write.

Thanks Kilrah.

I was not expecting this type of copying procedure.

RTG