SR10 Pro - Channels?
- mapes12
- Posts: 138
- Joined: Tue Jul 09, 2013 6:44 am
- Country: United Kingdom
- Location: Lichfield UK
- Contact:
SR10 Pro - Channels?
Just bought one of these new Archer receivers. There are 10 PWM outputs but the manual appears to have been created by cut n pasting the channel configuration from the S8R manual. For instance, channel 9 for gain, channel 10 (Quick Mode) for flight modes. How can this be so when these channels have PWM pins? Has anyone set up one of these receivers yet?
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: SR10 Pro - Channels?
With the ACCESS protocol, you may map any receiver output to any channel (set in the Tx).
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- mapes12
- Posts: 138
- Joined: Tue Jul 09, 2013 6:44 am
- Country: United Kingdom
- Location: Lichfield UK
- Contact:
Re: SR10 Pro - Channels?
Penny has dropped.........
So, for example, channel 13 could be assigned to pin 9 and channel 14 to pin 10. Thus preserving the pins as being usable. Have I got this right?
So, for example, channel 13 could be assigned to pin 9 and channel 14 to pin 10. Thus preserving the pins as being usable. Have I got this right?
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: SR10 Pro - Channels?
Yes.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- mapes12
- Posts: 138
- Joined: Tue Jul 09, 2013 6:44 am
- Country: United Kingdom
- Location: Lichfield UK
- Contact:
Re: SR10 Pro - Channels?
The attached is a how to I found on another forum demonstrating how to change the pin channel order on SR10 Pro Rx.
- Attachments
-
- SR10Pro_HowTo.pdf
- (4.21 MiB) Downloaded 394 times
-
- Posts: 1
- Joined: Mon May 17, 2021 2:48 pm
- Country: -
Re: SR10 Pro - Channels?
hello peter
thank for your pdf. ich have tested on my ethos.it a little diffrent but i can use ch 9 an 10.
but i will use ch 2 and 13 for ele. ist works stick input . but when i start the gyro then works only one servo the secound one do not turn.
who is the fail? any idears? thamks