Taranis X9D+ Telemetry connection problem

Cant get your radio to work? General Hardware issues?
Post Reply
Rappi
Posts: 2
Joined: Fri Jan 16, 2015 8:50 pm
Country: Germany
Location: Zülpich

Taranis X9D+ Telemetry connection problem

Post by Rappi »

Hello,
I have a Taranis X9D+ with latest non EU firmware and OpenTX 2.1.3.
I use a X8R receiver with latest non EU firmware.
The flight controller is a APM 2.6 connected with S-Bus to PPM decoder.
The telemetry is connected via a Teensy 3.2 to S-Port.
I switch on my Taranis, then I switch on the receiver.
Telemetry is working. After about 50 sec. Taranis beeps 2 times and rssi goes to zero.
All telemetry screens are like frozen and "no data" is displayed.
Remote control is completly possible.
Telemetry doesn't restart after switching Taranis Off and On after 10 sec.
After about 5 min all off it works again for app. 1 min., sometimes it works for 3 to 5 min.

I have had the same problem with a D8R-XP receiver.

Sometimes it works for longer time, but I don't know why.

Is this a OpenTX setting or is this a hardware fault.

Please help me.

Rappi

User avatar
dinamich
Posts: 288
Joined: Mon Apr 01, 2013 1:21 pm
Country: Slovenia
Location: Ljubljana

Re: Taranis X9D+ Telemetry connection problem

Post by dinamich »

Lets try a simpler case first. Disconnect cable between RX and Teensy. That way you will only get basic telemetry like RSSI and SWR. See if that changes anything.
projectkk2glider@github
Rappi
Posts: 2
Joined: Fri Jan 16, 2015 8:50 pm
Country: Germany
Location: Zülpich

Re: Taranis X9D+ Telemetry connection problem

Post by Rappi »

I have the same problem. I tested with RSSI and RxBt. After app. 1 min. two beeps and RSSI is zero. RxBt and RSSI value is flashing. On bottom line "no data".

Edit:
I made a video of the problem: https://vid.me/YcTb

2nd Edit: I send the Taranis back for waranty check.

Finally closed. The problem was a hardware problem inside the Taranis. I got a new one and all works as it should.

Post Reply

Return to “Hardware”