Good stuff.
Incidentally, since you reported yours breaking... I've had at least a dozen similar reports I don't know if they had the temperature wrong, or what... but they aren't holding up. Unfortunately, I shipped about 125 before realizing there was a problem. I'm now reinforcing each one by over-soldering the four corner posts prior to shipping.
- Steven
AVRDUDE did not finish correctly
Re: AVRDUDE did not finish correctly
Alright. We got another winner
Edit. - I never saw Steven's reply when this was posted. My comment is confusing at best but was in regards to the OP getting his issue determined.
Edit. - I never saw Steven's reply when this was posted. My comment is confusing at best but was in regards to the OP getting his issue determined.
Last edited by rperkins on Fri May 11, 2012 11:46 pm, edited 1 time in total.
- MojoMaestro
- Posts: 143
- Joined: Sun Jan 29, 2012 1:32 pm
- Country: -
- Location: Montreal, Quebec, CANADA
Re: AVRDUDE did not finish correctly
I was thinking to reinforce mine with CA or Hotglue on the sides.
U think it's ok Steven.
U think it's ok Steven.
Verus Amicus est Tanquam Alter Idem
Re: AVRDUDE did not finish correctly
I've heard that ca can be conductive.
-gohst
Sent from my LG-P999 using Tapatalk 2
-gohst
Sent from my LG-P999 using Tapatalk 2
Re: AVRDUDE did not finish correctly
Conductive wouldn't be a problem if applied as if it were solder (ie. careful to keep it to just the "shell" and not let it touch any of the pins or pads other than the ones directly touching the "feet"). Afterall the solder is conductive! However, I can't say whether or not glue would be effective.
- Steven
- Steven
- MojoMaestro
- Posts: 143
- Joined: Sun Jan 29, 2012 1:32 pm
- Country: -
- Location: Montreal, Quebec, CANADA
- MojoMaestro
- Posts: 143
- Joined: Sun Jan 29, 2012 1:32 pm
- Country: -
- Location: Montreal, Quebec, CANADA
Re: AVRDUDE did not finish correctly
Ok what i mean is not to repair my broken piece but to
reinforce my new one in order to avoid it from happening again.
Where the green lines are, that is where i would put HotGlue or CA.
reinforce my new one in order to avoid it from happening again.
Where the green lines are, that is where i would put HotGlue or CA.
Verus Amicus est Tanquam Alter Idem