This one's got me baffled - anyone experienced similar or have any idea of the cause.
Specs:
Recently flashed 9x TX to er9x r-782 for first time.
Has 1kohm mod for trainer installed on board inside back case
Has HK backlight plus mosfet mod to enable on/off control of backlight
ALL channels output no problem to the receiver
Default is AETR and Mode2 sticks
'Model' is setup from new with basic 4 channel template added
When I connect to Clearview it receives channels 2-4 no problem but does not respond to channel 1 (I've mixed channel 1 source for all sticks and pots and no difference) ie Clearview's "x-axis" input remains silent.
I was able to find a way around this because channel 5 in mixes feeds a signal to Clearview's "x-rotation" channel - hence set AIL on ch5 and change Clearview input for Ailerons to "x-rotation".
Previously I was receiving 5 channel inputs from stock Tx so could at least enable flaps.
Really curious to know if anyone can solve this 'riddle'...
Clearview simulator does not receive Ch1 (x-axis) input
- gastolectric
- Posts: 46
- Joined: Wed Jan 09, 2013 7:59 pm
- Country: Australia
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Clearview simulator does not receive Ch1 (x-axis) input
Try changing the "Shift Sel" in the model setup between NEG and POS.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- gastolectric
- Posts: 46
- Joined: Wed Jan 09, 2013 7:59 pm
- Country: Australia
Re: Clearview simulator does not receive Ch1 (x-axis) input
No joy - kiils all input to Clearview if i switch to NEG
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Clearview simulator does not receive Ch1 (x-axis) input
OK, now try changing the value of the pulse width. The default is 300uS, try 400 and/or 200uS.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- gastolectric
- Posts: 46
- Joined: Wed Jan 09, 2013 7:59 pm
- Country: Australia
Re: Clearview simulator does not receive Ch1 (x-axis) input
Hah, you're a genius - it still only works on 300uS but guess what - set the option next to this from 8CH to 6CH and presto - I have 6 channel input to Clearview.
So, THR on Z axis
RUD on Z Rotation
AIL on X axis
ELE on Y axis
Flaps (P1) on X rotation
Gear (GEA) on Y rotation
And throttle kill on RUD switch to practise heli auto-rotations (what fun)
Thanks Mike!!
So, THR on Z axis
RUD on Z Rotation
AIL on X axis
ELE on Y axis
Flaps (P1) on X rotation
Gear (GEA) on Y rotation
And throttle kill on RUD switch to practise heli auto-rotations (what fun)
Thanks Mike!!