Using Cross-Fire with Arduino instead of Flight Controller

Cant get your radio to work? General Hardware issues?
Post Reply
Sattva
Posts: 1
Joined: Fri Oct 23, 2020 7:16 am
Country: Ukraine
Location: Kiev
Contact:

Using Cross-Fire with Arduino instead of Flight Controller

Post by Sattva » Sun Oct 25, 2020 1:36 pm

Hello.

I have 10 kWt BLDC motor with special controller that accepts 0 to 3.6 Voltage as a standard accelerator pedal (throttle) input.

Successfully tested it with

Code: Select all

FS-IA6B -> PWM signal -> Arduino Uno -> DAC 0..3.6V -> Throttle Controller input -> BLDC Motor 10 kWt
Use 5 channels and works fine with Radiomaster TX16S.

Now want to use Cross-Fire receiver.
i-Bus protocol must be possible to use with
either Arduino or ESP32.
Is here anybody with successful experience on such type of communication?


User avatar
Kilrah
Posts: 10739
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Using Cross-Fire with Arduino instead of Flight Controller

Post by Kilrah » Sun Oct 25, 2020 2:41 pm

Configure the receiver to put out SBUS, there are lots of documentation and libraries for that.

Post Reply

Return to “Hardware”