I am having trouble installing open tx on my Turnigy 9x. When I try to read the radio on companion 2.1, i get the message,
device signature = Oxle9702
Expected signature for ATMEGA64 is 9602.
How do I fix this?
Any help is appreciated.
Thanks
Can’t flash OpenTX onto Turnigy 9x. Help....
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Can’t flash OpenTX onto Turnigy 9x. Help....
Your radio has a ATMEGA128, so just select that.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Can’t flash OpenTX onto Turnigy 9x. Help....
Thanks mike! I got past that part.
When I went to flash OpenTX onto it, everything looked normal and then it finished. When I turned on the radio, it still had the original Turnigy firmwear on it. So I tried it again but this time I noticed it said that it was reading the firmware and completed without saying it was writing the firmware. Then I tried to read the firmware and it gave me a eeprom invalid error.
What am I doing wrong? (I’m a complete noob at flashing raidios and OpenTX)
Thanks
Jonathan
When I went to flash OpenTX onto it, everything looked normal and then it finished. When I turned on the radio, it still had the original Turnigy firmwear on it. So I tried it again but this time I noticed it said that it was reading the firmware and completed without saying it was writing the firmware. Then I tried to read the firmware and it gave me a eeprom invalid error.
What am I doing wrong? (I’m a complete noob at flashing raidios and OpenTX)
Thanks
Jonathan
Re: Can’t flash OpenTX onto Turnigy 9x. Help....
Never mind. Got it to work