Sequential Retractable Undercarriage

[EdgarS]

Hi, I have Taranus X9d plus updated to Open Tx 2.22 so have Lua scripts etc. I have electric retracts for my Hurricane each of which is are normally connected by Y lead to the receiver. They could of course be fitted individually to 2 channels of the receiver. They naturally retract together. On a full size Hurricane one leg retracts before the other. My question. Using this very clever transmitter is there any way I can programme it so that when I operate a switch it will retract one leg before the other? Any help suggestions appreciated. Edgar

[jhsa]

Connect each one to its own channel, then apply a delay to one of them.

João

[EdgarS]

Thanks, you have send me an excellent range of Videos. To save a lot of time going though them, which one shows how to set a delay please?
Another query. I have just found when setting up a new model recently installed Open Tx 2.22 , that the Model Setup shows Failsafe mode in D16 but not in LR12 mode?
Is this normal or a peculiarity of 2.22. Can I set up failsafe any other way? (using L9R receiver) thanks for any help. Edgar

[jhsa]

I haven't sent you any videos But you can refer to the opentx manual and learn how to set a delay on a channel..

I don't use opentx, I use ersky9x..

João

[EdgarS]

Thanks João, found it in Open Tx, easy when you know how is it not!!
Excuse mix up but with your reply came
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=P ... qcuIqJXhb9
Which I assumed you had sent.
Regards Edgar

[jhsa]

Ah, those links to my videos about Er9x and Ersky9x are attached to all of my posts

João