Taranis xd9 plus se set up questions ?
Posted: Wed May 16, 2018 5:53 am
I knew it wouldn't be long before I had to ask a question about the Taranis set up.
I've been using Spektrum tx's for over 20 years so bear with me here please as the Taranis is going to be a steep learning curve from what I'm used to......
After watching many YouTube videos about setting up the Taranis I have somehow managed to update to 2.2.1 and changed the Sd card to the latest firmware and flashed a R-SXR receiver to the latest firmware (although I haven't bound it yet so hopefully it will work ?) .....All good so far but these are the two questions I have......
1. When I create a new model I don't have a helicopter image just a plane a glider and a multirotor and no I didn't click 'noheli' on the tx firmware screen and I do have a page in the model dedicated to heil's. How do I get the helicopter selection back ? (Photo below)
2. Although I have 2.2.1 on the tx the bootloader only shows 2.1.6 (Photo below) tried writing to tx but doesn't seem to want to ?
I do have more questions about receiver connections to FC but I haven't got that far yet so if anyone can answer the first two questions is appreciate that to start with
I've been using Spektrum tx's for over 20 years so bear with me here please as the Taranis is going to be a steep learning curve from what I'm used to......
After watching many YouTube videos about setting up the Taranis I have somehow managed to update to 2.2.1 and changed the Sd card to the latest firmware and flashed a R-SXR receiver to the latest firmware (although I haven't bound it yet so hopefully it will work ?) .....All good so far but these are the two questions I have......
1. When I create a new model I don't have a helicopter image just a plane a glider and a multirotor and no I didn't click 'noheli' on the tx firmware screen and I do have a page in the model dedicated to heil's. How do I get the helicopter selection back ? (Photo below)
2. Although I have 2.2.1 on the tx the bootloader only shows 2.1.6 (Photo below) tried writing to tx but doesn't seem to want to ?
I do have more questions about receiver connections to FC but I haven't got that far yet so if anyone can answer the first two questions is appreciate that to start with