Page 1 of 1

IMAC Programming for X10S on OpenTx

Posted: Mon Aug 31, 2020 10:45 pm
by ripper911
Hello all. I am hoping to set up my X10S to emulate the programming that usually goes into a 16MZ, 18MZ or 32MZ Futaba radio with flight modes and stick switches for Intermediate and up IMAC flying.

I have used up all 8 of the OpenTx flight modes and now I am trying to figure out how to add snap rates based on stick switch positions. I am thinking I would need right and left positive and negative snaps on uplines, downlines and horizontal flight.

Hopefully someone has delved into the OpenTx programming necessary to achieve this type of setup or perhaps someone has wrote a lua script for something like this.

Thanks in advance.

Any guidance is appreciated.

Regards,

Robert