Gents, I am running 2.2.0 in the Taranis, and screenshot is working just fine. However, for some reason I cannot find all screenshots I took, but the last batch.
Here is the situation. I put together a function to take a screenshot of the telemetry screen every 3 seconds, that I enable with a switch.
Now, during a flight I enable the screenshot sequence 2 or 3 times, for example on take off and landing approach. What I found is the the takeoff sequence is not there. Therefore, the question is if there is any restriction on the number of screenshots I can get (kind of a loop recorder), or other process that delete the shots for whatever reason.
Thank you
Transmitter screenshot
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Transmitter screenshot
Richard
Re: Transmitter screenshot
Not that I know of.
How did you do the 3sec timing?
How did you do the 3sec timing?
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Re: Transmitter screenshot
I created a logical function
LXX a>x Timer3 00:00:03
And two Special Functions
SG UP ---> Set timer3---> 00:00:00 This will keep timer 3 from running if SG is up
LXX ------> Reset timer 3 This will reset the timer back to 0 when it reaches 3 sec, (assuming SG is NOT UP),
and start counting again, until I Disable it (SG UP).
I'll keep trying. There may be something I am missing in the way it's working.
Will report whatever I get.
LXX a>x Timer3 00:00:03
And two Special Functions
SG UP ---> Set timer3---> 00:00:00 This will keep timer 3 from running if SG is up
LXX ------> Reset timer 3 This will reset the timer back to 0 when it reaches 3 sec, (assuming SG is NOT UP),
and start counting again, until I Disable it (SG UP).
I'll keep trying. There may be something I am missing in the way it's working.
Will report whatever I get.
Richard
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Re: Transmitter screenshot
Kilrah,
I did some modifications on the timer.
See attached the screenshot of the timer setting.
Logical functions is the same
LXX a>x Timer3 00:00:03
Special Functions are:
LXX Reset timer 3
LXX screenshot.
I eliminated the condition from SG to run the timer. Instead I control the timer with SF from the Setup Tab.
I did some modifications on the timer.
See attached the screenshot of the timer setting.
Logical functions is the same
LXX a>x Timer3 00:00:03
Special Functions are:
LXX Reset timer 3
LXX screenshot.
I eliminated the condition from SG to run the timer. Instead I control the timer with SF from the Setup Tab.
Richard