openrcforums

old loads from my backups work fine but when I try to simulate the latest download from the taranis plus, the switches and pots do not show up in the simulator. Went back and forth: olds work and new .otx does not show switches and pots for any of the models in the simulator. The compare function does not reveal anything: one model for example only has a trim difference. I don't see anything in the simulator view options. Ideas? where can I look?
Mike

Radio general settings, Hardware tab, pots are likely not set correctly.

I'm having the same problem with the X9D Plus, all switches and pots are there BUT the two sliders (in the simulator) aren't there. I did check the hardware tab, and all look ok.

Hum found why (in my case), I was not using the proper radio profile (was using the x9d instead of the x9d+) AND after changing it I had to click the "Store calib and hw settings in selected profile" a the bottom right of the (model) radio settings two make them show up.