r222 has been released since then, quite a lot of changes:
Changelog:
Fix SPort telemetry passing to script bug
Add uS value at top of MIXER display
Fix bug in telemetry buffer size testing
Script adds "bitfield" and "power" and "crossfirereceive" functions
Minor edits to remove warnings from newer compilers
Fix failsafe settings not being saved when changed
Display "FMx" when no name available for flight mode
Add "Run APP" in bootloader
Fix inverse video bug fix for "off grid" text.
Fix bug in script language bitfield function.
Limit exponent in script power function to a max of 20.
Fix value of A1 and A2 in a script
Add safety switches display of channel uSec output and ability to set the safety value to a resolution of 0.1%
Add ability to edit model notes
Add RunT "telemetry" value - Radio on time
Prompt for reset of Radio on time when battery detected as possibly charged
XJT module has "double rate" option to reduce latency
Atmel based radios add PB14 option for XJT heartbeat
Atmel based radios, offer PA25 as extra switch input where possible
Add ModT "telemetry" value - Model use time
Horus, implement the "doublerate" XJT driver.
Wide screen radios, fix bug when editing custom telemetry screens.
Support FrSky XLite
Fix bug on SKY/PRO/AR9X module output for Multi/Dsm
Fix General menu model voice file bug
Reset Telemetry now a popup option, not on LONG EXIT
Fix problem editing S6R/S8R values when "Menu only Edit" is enabled
Fix GPS altitude display scaling
Fix problem using encoder on Script selection
Fix FrSky Hub Altitude bug
Fix Voice alert BOTH with short filenames
Enhancements to script language
Add crossfiresend() to scripts
Fix voice overrun problem on Atmel radios (SKY/AR9X/9XR-PRO)
Add |d|<val to voice alert functions
Support inverted SPort polling on COM 1 for Multi Module
Support Jumper T12
Add "double click" on encoder button - toggle GVAR
Press and hold encoder button for fast editing
Delay loading of model scripts
Support MOVE for voice alerts
Bluetooth Tx signal held low for external power switch
Handle unknown SPort IDs
Add trims as Mix sources
FrSky XJT Rx numbers default to model slot
Add "double click" on menu button - toggle GVAR
Fix bug in logging of Lat and Long
Scalers support second source
Rx detection at power off revised
Fix bug in Crossfire telemetry sending from scripts
Add use bluetooth/COM2 from scripts
Fix bug on trim switches not working as push buttons
Support FrSky R9M module and flex mode firmware
Add bootloader for Horus X12
Add RTC battery voltage monitoring
Add custom names for custom telemetry values
Fix Vspd logging
Fix Vspd scaling from DSM telemetry
Voice alerts may use system voice files
Allow FM0-FM6 as switches for DR/EXPO
Limit FrSky RxNum to 63, max actually allowed.
Encoder double-click switches between CAPS when text editing.
Add Cls1 and Cls2 for total cells of two FLVSS/MLVSS
Fix Scaler ex_source editing bug
Scaler and Custom telemetry names used
Raw logging has a Hex option
Fix Crossfire telemetry bug
Handle FrSky vario from XxR when using 'D' protocol
This is available at
www.er9x.com.
You may also download "test" versions from the erskyTx test versions thread on here. While called "test", they are fully functional unless the note under the link indicates otherwise.
Mike