mstrens wrote: ↑Tue Oct 31, 2017 8:20 pm
You can already send "test_1" (being filled with the model ID) in T1_SOURCE or T2_SOURCE.
Why do you want to use FUEL_SOURCE?
Because when I`m looking at
FrSky HUB protocol I see FUEL LEVEL as the least significant measurement/ parameter. I think not many people are flying gas models even with fuel level sensor. Another measurements ( volt, temperatures, GPS etc. ) can be commonly used. OK, I have a question about Acc X,Y,Z, what is it commonly used for, but MPU-6050 is quite cheap sensor, maybe somebody will find some usefull aplication
From my scope of OpenXSensor use: MS5611 for altitude, MPXV7002DP + ADS1115 for speed, GPS as option, two DS18B20 for Temp. I use APM power module as Current/ Voltage sensor connected to A1/ A2 inputs on D8R II receiver, but X-series FrSky receivers doesn`t have two analog inputs, so volt/ current parameters in protocol is necessary for them.
That`s my reason, why FUEL LEVEL. Your opinion?