3D printable case for GPS/Vario sensor

[Emanuel]

Hi All,

I could not find any printable cases for these sensors so I designed my own. Hope you like it !

https://www.thingiverse.com/thing:4561104

Regards,

Emanuel

[bob195558]

Hi Emanuel,
The link does not work correctly or something ?
(404 YOU HAVE REACHED THE END OF THE THINGIVERSE).

Also maybe good to post it here "3D Printing": https://openrcforums.com/forum/viewforum.php?f=129

[Emanuel]

Thanks for the heads up. I think its fixed now.

[Kilrah]

Still broken

[Emanuel]

Found the issue. I could only see this Thing myself as I did save it, but did not 'Publish' it correctly. Should be better now. Sorry!

[Weds]

All good now...

[bob195558]

Hi Emanuel,
Looks good, well done !

I use Simplify 3D slicer and I have been trying to separate the two parts without success.
I would like to try printing the top cover on it's side as I believe would then be able to print without supports.

Is there a way to separate the two halves in Simplify 3D
so I can flip the top cover on it's side ?

[Emanuel]

I will put both separate files on Thingiverse. I prefer to print them like shown with some support underneath the top cover.

[bob195558]

Thank you !