Hi,
A friend want to use an oxs with vario and gps on a mx16, i did this config but nothing run with his radio (i use the same hardware and config except for hott protocol for the taranis and everything is ok), i also made a pullup to bring the 3volts to the gr12l, can you tell me if there is a mistake in my code, and what configuration i have to put on this radio.
Thanks for your help
graupner mx16 hott
Moderator: rainer
Re: graupner mx16 hott
I do not see a real mistake in your config.
Still I noticed that you declare a current sensor but not a Gps.
A fiend of mine reported that he could not use oXs with an old Graupner TX. I do not know if his radio uses the Hott protocol.
I do not have a TX/RX using Hott protocol so I can't confirm that oXs works fine.
Normally it should but perhaps someone else can confirm that it really works.
Still I noticed that you declare a current sensor but not a Gps.
A fiend of mine reported that he could not use oXs with an old Graupner TX. I do not know if his radio uses the Hott protocol.
I do not have a TX/RX using Hott protocol so I can't confirm that oXs works fine.
Normally it should but perhaps someone else can confirm that it really works.
Re: graupner mx16 hott
Oups this is the good file...we have a current sensor too, the radio use a smartbox(update last year) and it is not really new.
Last edited by ronron84 on Wed Jul 29, 2020 8:39 pm, edited 1 time in total.
Re: graupner mx16 hott
You still have
#define ARDUINO_MEASURES_A_CURRENT YES
I do not know if this is what you wanted (not needed for vario + gps sensor).
Anyway, this should not be the reason fot not getting data on the Tx
#define ARDUINO_MEASURES_A_CURRENT YES
I do not know if this is what you wanted (not needed for vario + gps sensor).
Anyway, this should not be the reason fot not getting data on the Tx
Re: graupner mx16 hott
thanks mstrens for your answer i was modifying my message as the same time you answered, there is a current sensor too in this config, for me it's not the problem, there is perhaps a radio configuration to do, i don't use a hott radio either i discover this radio today! the telemetry smartbox brings back hott vario and few data like receiver temperature.
Re: graupner mx16 hott
Hi,
we did it with a receiver GR12L! it's running good now. 1 reset the receiver 2 binding again with the radio and assign it.
we did it with a receiver GR12L! it's running good now. 1 reset the receiver 2 binding again with the radio and assign it.