Brushless rpm sensor from esc output wires

Development & General Chat for the superb openxvario project.

Moderator: rainer

Post Reply
Posts: 5
Joined: Fri Mar 29, 2019 1:28 pm
Country: -

Brushless rpm sensor from esc output wires

Post by Juhani » Sat Apr 27, 2019 5:07 pm


Found this line in the description: It is also possible to build a small PCB board that will provide pulsed when connected on a brushless wire.
Searched this forum and tried to google but didnt find any leads.

Has anyone made or can give me directions to this kind of schematic?

I have seen hobbywing rpm sensor but would like to try to diy and fail before buying it. :D

And again, many thanks in advance!

User avatar
Posts: 810
Joined: Sat Mar 29, 2014 10:59 am
Country: -
Location: Moenchengladbach

Re: Brushless rpm sensor from esc output wires

Post by kalle123 » Sun Apr 28, 2019 5:46 am

I use my DIY rpm sensor with oXs.


The hobbywing rpm sensor also works fine.

Have a look at my German thread here .... ... hlight=rpm
(6.07 KiB) Not downloaded yet

Post Reply

Return to “OpenXVario - an open source vario supported by the open source firmwares!!”