Neodymium Magnets upgrade on Heatbed (CR10 3D Printer)
Install TH3D High Temperature Neodymium Magnets to the CR10 3D Printer
Heat-Bed Upgrade with Neodymium Magnets to hold EZFlex-Sheet with EZMat Sheet
1) Purchase TH3D High Temperature Neodymium Magnets for EZFlex-Sheet.
Note: TH3D Neodymium Magnets have been replaced with EZFlex Magnetic Base,
See here for more info: https://www.th3dstudio.com/product/ezfl ... etic-base/
Also see here for the EZFlex System – Flexible Print Surface Bundle: https://www.th3dstudio.com/product/ezflex-plate-bundle/
2) Remove CR10 Heat-Bed by disconnection the power cable and the four leveling adjuster wheels.
3) Clean the backside of the Heat-Bed with 91% Isopropyl Rubbing Alcohol
4) Attach Neodymium Magnets to backside of the Heat-Bed.
5) Reassemble Heat-Bed with EZFlex-Sheet and make proper adjustment for the next print.
Note: Also I added Cork Tiles to insulate the backside of the Heat-Bed,
see here for more info: https://openrcforums.com/forum/viewtopi ... 85&t=12328
Upgrading Heat-Bed with High Temperature Neodymium Magnets (CR10 3D Printer)
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Upgrading Heat-Bed with High Temperature Neodymium Magnets (CR10 3D Printer)
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).