When the filament is getting caught (tangle) on the spool. (CR10 3D Printer)

Projects that are not for RC, but are cool and worthy of development.
Post Reply
User avatar
bob195558
Posts: 2073
Joined: Sun Dec 16, 2012 7:24 pm
Country: United States
Location: New England, Vermont
Contact:

When the filament is getting caught (tangle) on the spool. (CR10 3D Printer)

Post by bob195558 » Sun May 12, 2019 7:49 am

When your filament is getting caught on the spool (tangle) how to fix this problem.

What has happened,
is when handling the spool of filament one to several of the
rapped filament strands have fall off the side
and not properly returning on to the spool.
If you look (study) closely, you will see the end filament strand that is coming off the spool
is under one or several of the other filament rapped strands.
When you are able to see this, pull the end filament strand back from under the filament strand or strands.
Then the filament will be able to exit the spool properly.
It can be difficult to see the problem.
tangle filament_1.jpg
tangle filament on spool
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.

3D Printing upgrades with (CR10 3D Printer): (http://openrcforums.com/forum/viewforum.php?f=85).


Post Reply

Return to “Other Electronic Projects”