In short, what this is:
Be over 1pc servo channel 5pcs ,independently of each other (!) Feed on and off electrical things.
The outputs are controlled to 8 pieces 0.5A Output from 2-2pcs switch 2 comes out. If they are connected in parallel with the output, then 1A Capacity controlled. The remaining 2pcs (3+2 = 5) 0.5A Output remains of the original in size.
The outputs of these types of (digital) controls are nowhere (HK than not).
The outputs are fully independent from each other 32pcs strict control servo position adjustability should the transmitter side. This ER9X and OpenTX a very easy mix.
Only in such a setting, you must mix:
Inside is a mix :
Then they just need to be adding!
The proper operation of that channel page (-100) must be moved (in this example, Channel 5):
A sample of my five channels individually did a switch, but it can be anything else, of course!
Anyone familiar with the digital weighting (2^x), it will be familiar with the weight values!
00000
00001
00010
00011
00100
00101
00110
00111
01000
etc. ....
Please see:
[BBvideo 640,480]http://youtu.be/E6jbXgE_I14[/BBvideo]
1 servo channel through 5 switching outputs (32 stage).
User manual:
RCS-1 manual (only for hardware)
Shematic:
Download pdf:RCS-1D shematic (pdf)
Firmware:D version 1.0 (HEX) for PIC16F628A
Independent 5 switch via 1 servo port (RCS-1D)
Independent 5 switch via 1 servo port (RCS-1D)
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!
Re: Independent 5 switch via 1 servo port (RCS-1D)
This is origin webpage:
http://rc-miskolc.emiter.hu/rc-miskolc/ ... Itemid=204
http://rc-miskolc.emiter.hu/rc-miskolc/ ... Itemid=204
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!
Re: Independent 5 switch via 1 servo port (RCS-1D)
what is voltage for led supported? 5V? 11V? Many of my leds/strip are 11V.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Independent 5 switch via 1 servo port (RCS-1D)
The ULN2083 driver is rated for 50V
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Independent 5 switch via 1 servo port (RCS-1D)
Excellent! thx.
Re: Independent 5 switch via 1 servo port (RCS-1D)
If you are using external voltage take it into the internal diodes as well!
(inside 2803!)
(inside 2803!)
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!