Quanum Nova

Electronic projects that are either related to the firmwares for the 9x, or simply great for radio control applications.
Post Reply
carter76
Posts: 1
Joined: Wed Oct 30, 2019 8:21 pm
Country: -

Quanum Nova

Post by carter76 » Wed Oct 30, 2019 8:23 pm

Hi,
I purchased a 2nd hand Quanum Nova from Ebay. I sourced batteries and a charger. I setup and attempted to unlock motors. Nothing I did or could find online would work. I get solid green light for GPS lock and flashing red.
I am able to get in calibration mode by holding both sticks to bottom right while turning transmitter on (Mode 1). I then get flashing green light and flashing red/yellow light. I spin drone flat 5 times then nose down 5 times but nothing changes.

Then more research online and downloaded mission planner. Flight data shows bad compass health. When i go to attempt to calibrate it shows compass 1 error 99 and numbers only get to 3 or 4. If i look at flight data compass heads is always showing 0 or -10 and wont change when spinning quad.

I have check cabling and plugs on both ends and all looks OK.

Can anyone assist as this has me stumped.


Sent from my iPhone using Tapatalk


Post Reply

Return to “General RC Electronic Projects and Discussion”