Page 1 of 1
Opentx 2.2.4
Posted: Sun Aug 11, 2019 3:55 pm
by Popoff
Just a matter of curiosity has anyone had any problems with the above,on on occasion my crowbrakes refused to work and I've also notice that I'm unable to create a powered model in the templates on the transmitter. To top it all I have all its cost me a model, So I'm now back with 2.2.3. Would be very interested if anyone has had a similar outcome
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 4:14 pm
by Kilrah
We have not had any reports of control issues on 2.2.4 after 20'000+ downloads.
There might be something wrong in your configuration. Saying what radio you're using and posting your model file could probably allow someone to help you find out what.
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 4:44 pm
by Popoff
The transmitter is Horus10s, I will send the model file later
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 6:20 pm
by Popoff
Please find the file attached, would be interesting to know what the problems is
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 7:22 pm
by rdeanchurch
If it does not work "on on occasion my crowbrakes refused to work".
I'ld be looking for connector problems.
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 7:37 pm
by Popoff
I looked on the monitor page and I could see that the travel was full in one direction, if I attempt to use the slider to correct it nothing happened
Re: Opentx 2.2.4
Posted: Sun Aug 11, 2019 8:08 pm
by rdeanchurch
Since I see no Sliders used in the .otx (FM, INPUTS, MIXES) That does not seem surprising to me.
Re: Opentx 2.2.4
Posted: Mon Aug 12, 2019 9:29 am
by Popoff
My apologies for uploading the wrong profile, unfortunately is looks like I've deleted it in anger. If the problem happens again I will ask for help, thanks to you all
Re: Opentx 2.2.4
Posted: Mon Aug 12, 2019 11:39 am
by Kilrah
A little piece of advice, if something "sometimes doesn't work" then stop and fix it, don't continue flying.
Re: Opentx 2.2.4
Posted: Mon Aug 12, 2019 12:40 pm
by jhsa
very good advice. better to have a spoiled flying day, than a spoiled flying day and a destroyed model.
João
Re: Opentx 2.2.4
Posted: Tue Aug 13, 2019 7:55 pm
by xxdvdxx
Hi, I have updated opentx to 2.2.4 and the firmware on my Horus X10s and the first issue was that in a model ( tricopter)all channel settings were not centered specially on rudder and throttle stick axis . Then I tried to recalibrate all channels ( I never had the need to recalibrate after every update before ), but I didn’t found the same point calibration as before . Plus in another model (delta wing ) I had on radio profile settings the TEAR channel order changed in TAER .. so don’t know ... it wasn’t a chase for sure .
Inviato dal mio iPad utilizzando Tapatalk