Could someone please tell me what's diameter are the adjusting screws, as wasn't able to find any to fit them. I'm assuming that they are allen screws type.
Sent from my SM-G955F using Tapatalk
Adjusting gimbal tension Horus10s
Re: Adjusting gimbal tension Horus10s
What do you want?
The diameter of the screws or the size of the key for adjusting those screws?
cu KH
The diameter of the screws or the size of the key for adjusting those screws?
cu KH
Re: Adjusting gimbal tension Horus10s
I wish to lower the tension on the sticks, have had the back off and found the adjustment screw. They look like Allen screws to me, but didn't have the right allen key size. It would be handy to know the size please
Re: Adjusting gimbal tension Horus10s
1.5 mm allen key.
Picture from Helle's German OpenTX manual (link to that manual can be found here in this forum)
viewtopic.php?f=92&t=3563&hilit=helle#p52110
cu KH
Picture from Helle's German OpenTX manual (link to that manual can be found here in this forum)
viewtopic.php?f=92&t=3563&hilit=helle#p52110
cu KH
Last edited by kalle123 on Sun May 12, 2019 6:15 am, edited 1 time in total.
Re: Adjusting gimbal tension Horus10s
Thanks Kalle123, that's good of you. All the best