Turnigy 9XR Settings
Posted: Thu Dec 28, 2017 10:52 pm
I would appreciate some assistance with my Tarot 680 PRO setup. I haven't had much luck since changing my DJT module and D series receiver to the module and receiver listed below.
TX: Turnigy 9XR Pro (XJT module) w/ersky9x-200, v. 1760-Mike
RX: FrSky X8R using SBUS
FC: Naza M V2
If anyone has the same setup I would appreciate information on the mixer settings and internal and external protocol settings. I have the DJI Naza software and eePe sky software. I've bound the receiver using jumpers on pins 1-2 and 3-4 then removed the jumpers. Motors won't respond. I think it is the TX settings. Again thanks for any help.
TX: Turnigy 9XR Pro (XJT module) w/ersky9x-200, v. 1760-Mike
RX: FrSky X8R using SBUS
FC: Naza M V2
If anyone has the same setup I would appreciate information on the mixer settings and internal and external protocol settings. I have the DJI Naza software and eePe sky software. I've bound the receiver using jumpers on pins 1-2 and 3-4 then removed the jumpers. Motors won't respond. I think it is the TX settings. Again thanks for any help.