IRX4 Plus

erskyTx runs on many radios and upgrade boards
ersky9x was a port of er9x for use on the sky9x board.
Post Reply
boowho
Posts: 50
Joined: Fri Dec 06, 2013 3:52 pm
Country: -

IRX4 Plus

Post by boowho »

Just got this TX module and have it all configured and working with my 9Xtreme (Smartie Parts) board. The question is why would/should I flash the 9Xtreme firmware FlashMulti_9xt.app (from Er9x.com). What benefit does it provide from the stock firmware that came with the IRX4 Plus?

Thanks

Boowho??

rcfish
Posts: 62
Joined: Tue Jan 10, 2017 8:11 pm
Country: Germany

Re: IRX4 Plus

Post by rcfish »

FlashMulti_9xt.app is only a app you can use to flash the multiprotocol. You have to compile your own version of the firmware from https://github.com/pascallanger/DIY-Mul ... e/releases with arduino. You have to use a special bootloader on the multiprotocol to flash the multiprotocol with ersky9x. I think before there were apps we used the maintance mode to flash the multiprotocol.
https://www.youtube.com/watch?v=5qWRaB-ei14 (usefull video by jhsa)
You have to put the .app into a folder on your sd-card called "apps".

rcfish
boowho
Posts: 50
Joined: Fri Dec 06, 2013 3:52 pm
Country: -

Re: IRX4 Plus

Post by boowho »

Thank you.....

Post Reply

Return to “erskyTx (was ersky9x)”