Let's see if I can explain this.... I've looked at the servo test mixes and and the switches that make it happen.
I need to be able to set up another switch (a "trigger" switch) that when flipped on causes the TX to cycle the test a given number of times.
For example, 10 iterations of the channel 15 output.
Then after the 10 cycles, stop and don't do it again until I switch the "trigger" switch off and then back on again.
Every time I cycle the "trigger" switch another 10 cycles are done. Is this possible??
Servo Test Template in EEPE
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Servo Test Template in EEPE
It may well be possible, but will probably depend on which revision of er9x you have flashed. Do you have r813?
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!