Helicopter curves question

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
boowho
Posts: 50
Joined: Fri Dec 06, 2013 3:52 pm
Country: -

Helicopter curves question

Post by boowho »

Attached is a "roll my own" mix definitions. This is Futaba channel layout CH 1 - AIL CH 2 - ELE and CH6 - PITCH.

The question is do I need to reference Curve 4 (Pitch Curve) on CH 1, CH 2 AND CH 6 (on the THR line) ..... Or is CH 6 the only one needing Curve 4 to be referenced?

Boowho??
Attachments
mixes.png
mixes.png (8.53 KiB) Viewed 3444 times

User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

Re: Helicopter curves question

Post by gohsthb »

You need to reference the curve everywhere you need it to apply. So yes it needs to be on 1, 2, and 6.
-Ghost
boowho
Posts: 50
Joined: Fri Dec 06, 2013 3:52 pm
Country: -

Re: Helicopter curves question

Post by boowho »

gohsthb wrote:You need to reference the curve everywhere you need it to apply. So yes it needs to be on 1, 2, and 6.
-Ghost
I thought so, but wanted to verify.

Thanks very much.

Boowho??

Post Reply

Return to “er9x”