ER9x PXX+FRSKY XJT=16 Channels

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
User avatar
QuarX
Posts: 7
Joined: Mon Feb 03, 2014 4:44 am
Country: Spain
Location: Granada

ER9x PXX+FRSKY XJT=16 Channels

Post by QuarX » Mon Feb 03, 2014 9:58 am

Hi,
I read lot of info about this but i´m a bit confused ( read about two receiver, or PXX only 8 chanels...) :?
Is possible now get 16 channels working in PXX mode with this config?

TX:
Th9x r809
Module XJT frsky

RX:
X8R-->sbus converter--> Flight controller Mikrokopter
I made several test and only get working PXX 8 channels in my th9x. :oops:

Thank you very much
Jose A.
It´s your fault HAHAHA...


User avatar
MikeB
9x Developer
Posts: 16795
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: ER9x PXX+FRSKY XJT=16 Channels

Post by MikeB » Mon Feb 03, 2014 10:21 am

Have you set the sub type to D16?

Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

User avatar
MikeB
9x Developer
Posts: 16795
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: ER9x PXX+FRSKY XJT=16 Channels

Post by MikeB » Mon Feb 03, 2014 11:15 am

I've just checked and PXX -> XJT -> X6R for 16 channels and it works OK. I configured the X6R to output channels 9-14 and it worked OK.

Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

User avatar
QuarX
Posts: 7
Joined: Mon Feb 03, 2014 4:44 am
Country: Spain
Location: Granada

Re: ER9x PXX+FRSKY XJT=16 Channels

Post by QuarX » Tue Feb 04, 2014 4:09 am

Thank you very much for your help, Mike.
You point me in the correct way...
The sbus to ppm converter has a jumper if install output chanels 1-12; if no present only channels 1-8 are output.
These are my fault to get more than 8 channels
Thank you again
Best Regards.
Jose A.
It´s your fault HAHAHA...


Post Reply

Return to “er9x”